In the case of bonsai, although small, they are also considered smaller trees. If for some reason the bonsai is completely dry, there is a way to restore it. As the environment is effecting everything around us, trees and plants are getting dried. This article is about how to save a dying tree.
Steps: How to save a dying tree
The first step we need to take is to remove the leaves that have not been able to fall off on their own, this helps prevent moisture loss. After that, we have to completely submerge the bonsai pot in water for about half an hour, after this time, we take the tree out of the water and put it in an inclined position to remove excess of this, and finally we place the bonsai with everything else and the pot in a transparent plastic bag and close it.
We need to keep in mind that the bag should not have direct contact with the tree and you should avoid placing the compost until it begins to heal, so this is a process that can take days or even months to see growth again. leaves, but that’s not a problem, you just need to be patient.
What kind of care a bonsai should have
In the case of larger trees, the procedure is the same, with the difference that we cannot remove it from the place where it was planted.
How to restore a dry plant?
The solution, in this case, would be basically to move the ground a little with a shovel, as we mentioned earlier, taking care of the roots. This will help the water more fluency, after this step we water the plant enough to keep the soil moist, after this step it is necessary to subject the tree to a series of special injection procedures depending on the drought condition.
Of course, this is a treatment that is professionally carried out by professionals who use a plastic injector that is inserted into the tree trunk.
In the case of plants that are planted in pots or those that are smaller in size planted in the garden, we can start with the following.
Read Also: Simple and Creative Tips to Decorate Your Garden
The first thing to do is to pierce the ground with a small shovel, spoon or any other utensil that can perform this function, after crossing the ground we dig quite wide holes to let the water through, of course, very carefully with the roots.
After that, the plant needs to be removed from the place where it was planted but bringing us a good piece of land, which we will later put inside a bucket of water, keep it at medium temperature until the soil is completely moist. When we see that the soil can no longer absorb water, we take the plant out of the bucket and place it on a flat surface to drain off the excess.
With the help of a water spray, we spread it on every leaf of our plant, given that this treatment requires a lot of patience, there is no need to worry about the results. To find out if the recovery had any effect, we can observe the plant after a few days, we will notice that the stems come to life and the leaves begin to turn green.
